MOTORHOME COVERS 

PLEASE CHECK STOCK AVAILABILITY BEFORE ORDERING

Water Resistant breathable Motorhome Covers.

• Heavy duty 4ply non-woven polypropylene fabric is UV stable, breathable and gives superior water resistant and protection from the elements.
• Breathable material allows moisture to escape so preventing damp and mildew to the motorhome.
• Elasticated hem allows a tailored fit over a range of motorhome sizes.
• Nylon straps on the sides, front and rear secure the cover firmly in place.
• Zip openings allows easy fitting and access.
• Protects against UV rays, rain, wind, smog, dust, snow and ice.
• Handy storage bag for when the cover is not in use.

Note: To ensure you get the correct Motorhome Cover measure the external length of the motorhome body at its longest point.

Click Here to see our full range of Caravan Covers.

See below for Motorhome Cover Fitting and Care Instructions.

MOTORHOME COVER FITTING AND CARE INSTRUCTIONS

IMPORTANT:

·         Do NOT use your motorhome’s heating system with the cover fitted.

 ·         Do NOT attempt to drive your motorhome with the cover fitted.

 ·         When opening and closing a zip, always ensure the cover surrounding it is straight and

      not too tight. This will prevent excessive strain and possible failure of the zip.

 ·         Do NOT over-tension straps as this may damage your cover.

 ·         Do NOT attempt to fit the cover in windy conditions. 

BEFORE FITTING YOUR MOTORHOME COVER:

·         Remove, fold away or cover any sharp or fragile objects (such as aerials, guttering,

     wing mirrors, awnings, and ladders etc) on the exterior of your motorhome to avoid

     damage to both them and the cover.

·         Close all windows and rooflights etc.

·         Ensure that fridges and heaters etc are turned off and the handbrake is applied.

·         It is preferable, but not essential, that your motorhome exterior is dry before fitting

     your cover. In order to prevent scratching, it MUST be clean and free of any loose

     particles or grit. 

FITTING YOUR MOTORHOME COVER:

Two people and the careful use of stepladders or a platform will be required as the cover is heavy and needs to be passed carefully over all sections of your motorhome.

1.    Open out the cover. The front section is clearly identified with a “FRONT” label.

2.    Unzip the rear panel.

3.    Starting from the front and working towards the rear, lift the cover carefully over the

     roof and all protruding objects. If necessary, unzip the front section also.

4.    Adjust the cover’s position until an even fit all over is achieved.

5.    Close the zips carefully and fasten the Velcro tabs, as shown in the photo on the box.

6.     Secure the sides of the cover with the straps provided. Pass each strap under your

     motorhome and secure to the corresponding buckle on the opposite side.

7.    Adjust all straps as required to give a good fit, including those on the front and the

     rear, as shown in the photo on the box.

CARE OF YOUR MOTORHOME COVER:

• Allow the cover to dry completely before storing in the bag provided.
• Do not machine wash or tumble dry this cover. Remove dirt with a soft sponge and warm water. Do not use detergent.
• Do not expose this cover to sparks, flames or other sources of ignition.

Leisure Mart for all your Motorhome Cover Requirements